GE MDS entraNET 2400, Technical Manual

Page: 124 / 220

114 MDS entraNET Technical Manual 05-4055A01, Rev. E
BOOT
—Bootloader Image
APP1
—Firmware application image 1
APP2
—Firmware application image 2
TOR1
—Tor 1 Image
TOR2
—Tor 2 Image
RADIO
Sets or displays the radio configuration and status.
Optional arguments:
AP=
—( read only ) Displays the associated AP Serial Number.
ASSOC=
—( read only ) Displays whether or not the Remote radio has
been associated with an AP.
CMD
—Displays all settable optional arguments and their current values.
You can copy this list to a text file as a record of your configuration.
NETADDR=<string>
—The current network address (1-15 alphanumeric
characters).
PWR=<dBm>
—Sets or displays the current power setting. The value is in
dBm, with an acceptable range of 0–30 for 900 MHz radios, 10–20 dBm
for 2.4 GHz ETSI radios, or 17–27 dBm for 2.4 GHz non-ETSI radios.
QUALITY=
—( read only ) Displays the quality of the over-the-air link,
expressed as a percent (0-100). Quality is calculated from the successful
reception of ACK packets sent by the AP (0-100).
REFRESH=<refresh>
—Connection refresh period in seconds (0–255). The
Remote inherits the
database timeout
value from the AP and applies that
value to the
refresh
parameter.
RSSI=
—( read only ) Shows the Received Signal Strength (RSSI). The
value is shown in dBm, with a range of -120 to 0. This value is refreshed
every 3 sec.
SYNC=
—( read only ) Shows the current state of radio synchronization.
TX KEY=<on, off>
—Starts or stops the transmitter test.
TX FREQ=<valid frequency range>
—Sets or displays the carrier frequency
(in MHz) for transmitter tests. The valid range is 902.2–927.6 for
900 MHz radios, or 2400.6–2482 for 2.4 GHz radios.
UNIT=<unit>
—The 32-bit user-programmable radio address, which
defaults to the radio serial number, but can be changed.