GE MDS entraNET 2400, Technical Manual

Page: 61 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 51
•
Auth Trap Enable
—Current state of the authentication traps.
[
Disabled/Enabled; Disabled
]
•
SNMP v3 Password Mode
—Determines whether v3 passwords are
managed locally or using an SNMP Manager. The different
behaviors of the Agent, depending on the mode selected, are
described in
SNMP Mode
above. [
Manager, Local; Manager
]
•
Trap Manager (#1–#4)
— Table of up to four locations to which
traps are sent. [
Any valid IP address
]
3.4.6 Bridge Configuration Menu
Invisible place holder
Figure 3-18. Bridge Configuration Menu
Invisible place holder
•
Ethernet Bridging
—Select the type of Ethernet frames sent over
the air to Remote radios. [
All, Disabled, No Broadcast/Multicast,
IP/ARP Only; All
]
•
Bridge Priority
—This value is used along with the MAC address
to define the bridge ID. The Bridge ID is used by the Spanning
Tree protocol to determine the root bridge in the network. This
value is useful for forcing a certain bridge to always be the root.
•
Bridge Hello Time
—Defines how often Spanning Tree protocol
Bridge Protocol Data Units (BPDU) are sent out by the AP.
Each bridge in the network should have the same hello time.
[
Number of seconds; 2
]
•
Bridge Forward Delay
—This value decides how long a bridge is in
the “learning” and “listening” states. Traffic begins forwarding
through the bridge after twice the Forward Delay time. [
Number
of seconds; 5
]