GE DPI 610 IS, User Manual

Page: 24 / 68

10
K249 Issue No. 4
Task Selection
Task Key
The TASK key is used to set up the instrument for a number of specific types of
test. There are two modes BASIC and ADVANCED and nine other specific types of
test which automatically configure the instrument on selection from the TASK
menu. The tasks available under the TASK menu are held on three pages shown
below. To select a task from the menu, press the TASK key, position the cursor over
the desired task and press the ENTER key as shown below. Use the right/left cursor
keys to switch between pages.
Using TASK Functions
Specific tasks are selected as shown above. The following diagrams show how to
connect the unit under test (UUT) for each task selectable under the TASK menu.
Input and Output units, where applicable can be selected by pressing either the
INPUT or OUTPUT keys as shown below.
Set Units
Note: If the four units displayed are not the units required, press SETUP , select
SETTINGS and refer to Page 36.