GE Carestation 620, User'S Reference Manual

Page: 104 / 268

Vaporizer installation
Use only Selectatec ™ series vaporizers Tec ™ 6 Plus or
greater.
Do not use a vaporizer that lifts off of the manifold when
the lock lever is in the locked position.
Do not use this anesthesia system if more than one
vaporizer can be turned on at the same time.
Electronic vaporizers with power cables will not align
correctly unless the power cable goes through the
channel on the bottom of the vaporizer.
Checking vaporizer installation
1. Make sure the top of the vaporizer is horizontal (not on
crooked). If a vaporizer is crooked, remove the vaporizer and
reinstall it.
2. Set each vaporizer lock lever to the locked position.
3. Try to lift each vaporizer straight up off the manifold rather than
pulling forward. Do not rotate the vaporizer on the manifold.
4. If a vaporizer lifts off of the manifold, install it again and repeat
steps 1, 2, and 3. If the vaporizer lifts off a second time, do not
use the system.
5. For a Tec 6 Plus vaporizer:
• Make sure that the vaporizer is connected to an electrical
outlet.
If the vaporizer is not connected to an electrical outlet and the
plug does not fit through the opening in the frame, disconnect
the power cord from the vaporizer. Route the vaporizer end of
the power cord through the opening from the back of the
system. Connect the power cord to the vaporizer. Route the
power cord through the channel on the bottom of the vaporizer.
Mount the vaporizer on the manifold and repeat steps 1, 2, and
3.
• Hold down the Auditory Alarm Mute (Audio Pause) button
for a minimum of 4 seconds.
• Make sure all indicators turn on and the alarm speaker
starts.
• Release the Auditory Alarm Mute (Audio Pause) button.
• Do not continue until the operational indicator turns on. The
concentration control will not turn if the operational indicator
is off.
6. Try to turn on more than one vaporizer at one time:
WARNING
•
•
•
Note
Carestation
™
620/650/650c (A1)
5-2
2076152-001