![background image](http://html1.mh-extra.com/html/gbc/f-60h/f-60h_operation-and-maintenance-manual_3941968035.webp)
Page 4 - 1
Installation
F 60 H Operation and Maintenance Manual
© April 2001 General Binding Corporation
Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor
free environment to operate properly. Do not
locate it where there is air blowing directly on the
machine.
Have you contacted a certified electrician to both
wire the laminator and ensure that adequate power
is being supplied, having the appropriate capacity,
over current protection and safety lockouts are
available?
W A R N I N G
The operating environment must be free of
dust, flammable liquids and vapors. You can
be injured by inhaling chemical vapors.
W A R N I N G
Vapor build up or stored flammable
liquids can cause a fire. Excessive
dust can damage the laminator.
C A U T IO N
D o n ot locate th e Falcon 60 H w h ere air is
b low in g d irectly on th e m ach in e. T h e air
flow can cool th e rolls u n even ly an d resu lt
in p oor outp u t q u ality.
4.0 Installation
GBC Films Group is committed to a program of
ongoing product improvement. As a result, we are
providing these instructions so you can insure that your
new Falcon 60 H Laminator is properly and securely
unpacked, moved, and installed. Installation should be
performed by a qualified technician.
Before a Falcon 60 H Laminator can be installed,
there are a few requirements that must be met. Make
certain that each of the requirements listed in the following
pre-installation checklist are met before beginning
installation.
CAUTION
Failure to follow the pre-installation check
list can result in damage to the laminator.
4.1 Pre-installation
Are doorways and hallways wide enough for the
laminator to be moved to the installation site?
Is there ample room for the laminator?
A work area must be established that allows for
operation in both the front and rear of the
laminator and provides space for efficient material
flow. Figure 4.1.1 illustrates a typical machine
area layout.