Page 6 - 12
© April 2001 General Binding Corporation
Applications
F 60 H Operation and Maintenance Manual
PROCESS CONTROL CHART
Materials - Mounting an image
Top material : N/A
Bottom material : N/A
Other material (s) : Image and a Pre-coated board
CAL 3200
CAL 3200
Motor Direction
Motor Speed
Roller Pressure
Upper Roller Temperature
Heater
RANGE
Notes: The image shoud not exceed the pre-coated board by more than 1 in. ( 2.5 cm ). If
the image is smaller than the precoated board, trim the board or pre-trim the release liner
around the image. Speed for mounting should be comfortable for the operator. Use the
footswitch for this application. Pressure will be dependent on the type of subtrate. No
heat is required for this application. Do not crush the substrate. Do not stop in the middle
of the run. Refer to helpful hints for mounting.
RANGE
1
2
3
4
5
6
7
8
9
10
rang
e
