Page 5 - 3
Operations
F 60 H Operation and Maintenance Manual
© April 2001 General Binding Corporation
5.2 Control panel
The operator control panel for the Falcon 60 H
Laminator is located to the right of the front operating
position. For an illustration of the complete front control
panel, please refer to Figure 5.2.1 Falcon 60 H. The
names and functions of these controls are as follows:
( 1 ) NIP PRESSURE DISPLAY: When pressure at
the nip of the rollers is applied, bars on the nip pressure
display are illuminated in increments of 5% up to 100%.
( 2 ) MOTOR ENGAGE/ DISENGAGE: When
pressed to the right, power to the motor is supplied and
the rollers will begin to turn. When pressed to the left,
power to the motor is removed and the rollers stop turning.
(disengage)
(engage)
( 3 ) FWD / REV: When pressed to the right, the motor
turns in a forward direction as illustrated by the image
above the switch. When pressed to the left, the motor
turns in a reverse direction.
(reverse)
(forward)
( 4 ) SPEED DIAL: When turned clockwise, increases
the speed of the motor. Turning it counter clockwise will
decrease motor speed.
1
2
3
4
5
6
7
8
9
10
( 5 ) TEMP ON/ OFF: When pressed to the right,
supplies power to the temperature controller unit located
just above it. When pressed to the left, removes power to
the temperature controller unit.
(off)
(on)
