60
61
1. empty the bean hopper and grinder. see above.
2. unplug the appliance.
3. remove the bean hopper from the grinder.
4. Grasp the upper burr by the handle and turn the upper burr counter-clockwise
to unlock it. Pull the upper burr out.
5. with the lower burr still in place, clean both burrs with a small nylon brush.
6. clean the grind outlet with a small nylon brush.
7. Pull the grind tray out of the base of the coffee Grinder. If used, pull the porta-
filter cradle out from under the grind outlet. open the grind tray.
8. clean the base and cover of the grind tray, portafilter cradle, bean hopper, and
bean hopper lid using a soft brush or a soft cloth and warm dishwater. Do not
use any hard or sharp-edged objects.
9. clean the razor™ tool with a clean, dry nylon brush.
imPOrtant:
It is essential to dry all parts of the appliance thoroughly after clea-
ning, as even small amounts of moisture may cause the build-up of lumps, thus clog-
ging the grinder.
10. wipe dry all parts thoroughly. leave dry naturally for at least 1 hour, where the
parts are out of reach of young children.
11. wipe the exterior of the appliance and the power cord using a soft damp cloth.
then polish with a soft dry cloth.
reassemBling the aPPliance
imPOrtant:
Before reassembling the grinder, ensure that all parts are complete-
ly dry. Any moisture within the grinding chamber or bean hopper would cause the
grinding chamber to clog with coffee powder.
1. Insert the upper burr into the grinding chamber and turn it until you can push it
firmly down into position and turn it clockwise to lock it.
2. replace the bean hopper. Press the bean hopper down completely, while turning
the lock clockwise until a click sounds and the bean hopper is fixed firmly.
3. replace the bean hopper lid. It is good advice to always keep the lid on the
bean hopper. this will protect the bean hopper and grinding chamber from dust.
4. If required, replace the razor™ tool and surplus blade into the grind tray.
5. replace the cover of the grind tray, and push the grind tray back into its place
in the base of the appliance.
6. If you wish to grind coffee powder for an espresso machine, push the appropri-
ate portafilter cradle back into the retainer under the grind outlet.
1
2
3
4
5
6
99
88
77
10
11
12
13
AIR TIGHT
CONTAINER
Unlock hopper Hold hopper over container &
turn dial to release beans into
container
Align hopper
into position
Run grinder
until empty
Remove hopper Remove upper
burr
Clean upper
burr with a
brush
Clean lower
burr with
cleaning brush
Clean grind
outlet with
brush
Push upper
burr firmly into
position
Lock upper burr Align hopper
into position
Lock hopper
