Component Power-Up and Configuration
03/07/03
8-3
CONFIGURING THE CHECKPOINT CONSOLE
With prior console models, configuration was accomplished with switches and jumpers. This
configuration procedure replaces the switch and jumper settings.
If the console has never been configured or if its configuration has been erased, it will go into
configuration mode at power up. Otherwise, you can access configuration mode by using self-test
7. Accessing self-test mode is described later in this section. The following table shows the
configuration options and their possible values. The shaded column shows the default value.
NOTE: If used, console printer address cannot be the same as the ICR receipt printer.
Summary of Contents for CFN Series
