CFN Series System
8-2
03/07/03
Fuel Point Reader (if used)
Locate and turn on the power switch in the top-left side of the FPR. Verify that the power
supply LED, visible through the perforated screen, is lit. Verify that the two RS-485 LEDs,
DL3 and DL4 on the FPR CPU PCB, are flashing.
Islander
Locate the memory PCB. When viewing the head of the Islander from the rear, the memory
PCB is located on the inside of right-hand partition, attached to the CPU PCB. The figure
below shows the PCMCIA slots on the memory PCB. The PCMCIA memory card supplied
with your Islander must be installed into the right-hand slot P2 (drive E:) before power is
applied to the unit. Insert the PCMCIA card with the keyed edge at the bottom into the slot
until the eject button clicks out.
Locate the AC power switch. When viewing the head of the Islander from the rear, the AC power
switch is located on the outside of the right partition near the base of the head. Push the switch
up to the
ON
position.
Summary of Contents for CFN Series
