GPS 500 Pilot’s Guide and Reference
12-15
SECTION 12
ADDITIONAL FEATURES
Switching Between Standby and Operating
Modes
The unit must be in operating mode for traffic to be
displayed. The ability to switch out of standby into operating
mode on the ground is especially useful for scanning the
airspace around the airport before takeoff. Operating Mode
is confirmed by the display of ‘OPER’ in the upper right-
hand corner of the Traffic Page (Figure 12-22).
Switching to Operating Mode from Standby
Mode:
1) Press the small
right
knob to activate the
cursor and highlight ‘STBY’.
2) Turn the small
right
knob to select ‘OPER?’.
3) Press the
ENT
Key to confirm and place the
GTS 8XX in operating mode, the GTS 8XX
switches out of standby into the 6-nm display
range.
NOTE:
The GTS 8XX will automatically switch out
of standby 8 to 10 seconds after takeoff, which
is determined by ground speed or by a transition
of the aircraft squat switch (if connected).
Switching to Standby Mode from the Traffic
Page:
1) Press the small
right
knob to activate the
cursor and highlight ‘OPER’.
2) Turn the small
right
knob to select ‘STBY?’.
3) Press the
ENT
Key to confirm and place the
GTS 8XX in standby mode.
NOTE:
The GTS 8XX goes into standby mode 24
seconds after landing, which is determined by
ground speed or by a transiton of the aircraft
squat switch (if connected). This delay allows
the GTS 8XX to remain out of standby during a
touch-and-go maneuver.
Traffic Page
Traffic can be displayed both on the Map Page (only
if heading is available) and on the Traffic Page (Figure
12-22). The orientation source shown at the top of the
display first uses heading (‘HDG’), then GPS Track (‘TRK’)
if no heading is available, to orient the display.
If the GTS 8XX does not have bearing information for
an active TA, ‘TA’ followed by range, relative altitude, and
altitude trend is displayed in the lower right corner. The
Traffic Banner is displayed if more than one TA with no
bearing info is active, while the TA of most immediate
threat is displayed in text below the banner.
Figure 12-22 Traffic Page
Orientation Source
Traffic Advisory
(with no bearing
information)
Display
Range
Operating Mode
Traffic
Traffic Banner
Traffic Page Display Range
The display range on the Traffic Page can be changed
at any time.
Changing the display range on the Traffic
Page:
Press the
RNG
Key to step through the
following range options:
• 2 nm
• 2 and 6 nm
• 6 and 12 nm
• 12 and 24 nm (GTS 820/850 only)
• 24 and 40 nm (GTS 820/850 only)
190-00181-60 Rev. G
Summary of Contents for GPS 500
