![background image](http://html1.mh-extra.com/html/gardner-denver/governor-ten014980/governor-ten014980_user-manual_563861164.webp)
13-17-621 Page 164
SECTION 6
DIAGNOSTICS
This section explains the diagnostics and troubleshooting options and settings available to the user. The
user can review and monitor the status of the machine in a number of different ways. Table 47 below gives
a brief summary about the sub-menus for diagnostics and brief information about each.
Table 47: Diagnostics
Diagnostics
Sub-Menu
Brief Information
The User can see the sequencing System Overview, including the status of online units, Sequence
#, loaded hours, etc.
The User can perform the motor jog by setting the parameters such as Jog Duration, Selected
Motor, and, Jog Delay.
The User can view the status of Digital, Temperature, and Analog inputs and outputs. Digital
outputs may also be controlled through this page.
The User can see the General and Advanced information about the controller, Logs, and System
status. Software updates may be performed through this page.
The User can see iConn info and status.
The Communication channel
’s status can be seen here.
The current state of all remote control functions can be viewed from this page.
The user can see the information about the variable frequency drive used on this machine, if
applicable.
6.1 Sequencing
The
Sequencing
Diagnostics page gives an overview of the sequencing settings for the machine. The
compressor name, run hours, capacity,
and
operating pressure
is also shown at the top of this page as well
as other information depending on the mode selected.
As more compressors are added to the sequenced network, the white space fills with additional compressor
information. Four compressors are shown in the example below. Each unit is represented by a rectangle
which has the information shown in Figure 162 below for the
ES+
sequencing protocol.
The screens will appear different depending on the sequencing protocol being used.
The
AirSmart
sequencing diagnostics page is shown in Figure 177 below. The
Delcos
sequencing diagnostics page is
different depending on if the machine is configured for a master or slave. Figure 178 and Figure 179 shows
the
Delcos
sequencing diagnostics pages.
Refer to Governor sequencing manual (
13-17-625
) for more detailed information on the sequencing
diagnostics.