2.9 - Replacement and adjustment of certain components
CAUTION!
The replacement and adjustment of components are extraor
-
dinary maintenance operations, therefore they shall be perfor
-
med by an authorized installation technician. Before starting
any repair or maintenance operation you must disconnect the
Also make sure that you close the water supply faucets.
Remember to put back the gaskets, the sealings and the insula
-
2.9.1 - Replacement of the safety thermostat
2 - INSTRUCTIONS FOR INSTALLATION AND MAINTENANCE
2.9.4 - Fan and motor
• From inside the oven remove the motor protection, unscrew the
screw that sets the fan loose, pull the fan out after having removed
the panel on the left side of the oven.
CAUTION!
Do not bend the fan while removing it and reassembling it.
The thermostat bulb is placed to the right of the cooking cabinet, be-
hind the tray rack:
1) Open the right side of the oven;
2) Unscrew the bulb inside the oven cabinet;
3) Pull out the thermostat wires and unscrew
B
-
ched on the back side of the control panel;
4) Place everything back in the original posi-
-
cal connections.
2.9.2 - Oven lamp
Proceed as follows:
1) Open the oven door (A
2) Turn the plastic locks (B
open (like opening a book).
3) Replace the light bulb (C
4) Reassemble everything in reverse order.
2.9.3 - Door gasket
• The gasket is pressed in, therefore it must
be extracted by pulling it out and inserted
by pressing it in again.
This operation must be performed ma-
nually so as not to damage the gasket.
