3 - INSTRUCTIONS FOR USE
100
000
08
00
TURNING ON AND OFF
When power is supplied, the card displays for several
seconds the software version.
Then the oven goes to the OFF status and on the time
display the LED is turned on and it stays on hold.
By pressing ON/OFF :
you turn the card on;
you turn on all the displays waiting for the introduction
of the set point;
default temperature is 100 °C;
default timer is 000, default humidity is 0.
When the temperature is set by turning the relevant
then accepts the set value, unless another knob is tur-
ned which causes immediate acceptance of the value
waiting for the set point.
When the time is set by turning the relevant knob, the
-
cepts the set value, unless another knob is turned which
causes immediate acceptance of the value and automa-
When the humidity value is set by turning the relevant
for 15 seconds and then accepts the set value.
During the cooking cycle, at the stage of variation of the
set parameters, by turning the relevant knob (temperatu-
re, time, humidity) it is possible to change the parameters
either by waiting for 15 seconds or by turning a knob.
In case the oven is stopped and no operation is perfor-
-
matically as if the OFF key were pressed.
The ON/OFF key is not active during the cooking cycle,
START/STOP key.
ON/OFF key or at
the end of the cooking cycle, the parameters last set are
stored for 5 minutes.
restarted, to the initial stage of value setting.
START/STOP KEY
By pressing the START/STOP key:
The cooking cycle starts, the internal light is activated.
The temperature display changes from visualization of
the set point to set chamber temperature and the rele-
vant LED turns on and stays on until the set point value
is reached;
again below the set point value.
o
t
t
n
i
o
p
t
e
s
e
m
it
m
o
r
f
s
e
g
n
a
h
c
y
a
l
p
s
i
d
r
e
m
it
e
h
T
-
mes permanently lit when the time is over.
