Gamewell Smart Start IDENTIFLEX 630, Installation & Operation Manual

Page: 168 / 226

IF 600 Firmware Version R7 Manual Supplement Issue 1 06/16/2000
52
SYSTEM PROGRAMMING
Programming System programming menus may be accessed if the proper programming password is
entered at the “ENTER PASSWORD:” prompt.
Programming may also be performed from a laptop computer connected to the RS-232
port on the CPU of the control panel. Refer to the end of this section for instructions.
>> NOTE: Before proceeding, notify all personnel, monitoring
companies and municipalities the system will be temporarily
"out of service". During all levels of programming, the system
will be in an off-line status.
System Menu The “System Menu” menu is displayed when selected from the programming mode menu.
System Menu
1=Display 2=Change 3=Test
0=Exit
Display Menu Selecting the “Display” option from the “System Menu” which allows the user to display
or download various system parameters. There are four options that may be selected from
this menu (see Figure 5-2) and four options that may be selected from the “MISC.” menu
selection. (Figure 5-3).
Display Menu
1=Config 2=Dict 3=Events
4=Misc 5=Detectors 0=Exit
Config Menu The Configuration Menu allows the user to select either displaying the system module
configuration or downloading the entire system configuration.
Configuration Menu
1=Display 2=Download 0=Exit