Gamewell Smart Start IDENTIFLEX 630, Installation & Operation Manual

Page: 130 / 226

IF 600 Firmware Version R7 Manual Supplement Issue 1 06/16/2000
14
Walk Test Prog Menu
1=Inputs 2=Inputs/Sig 3=Devices
4=Clear 0=Exit
1=Inputs Places all inputs in Walk Test
2=Inputs/Sig Places all Inputs and Signal Circuits in Walk Test
3=Devices Allows individual selection of Inputs and Signal circuits to placed in Walk Test
through the following procedures..
Figure T5 is now displayed. Use the up/down arrow keys to select the circuit of the
devices to be tested.
>> NOTE: Use the right arrow key to move the cursor under the
device address.
CKT:XX Add:XXX D_Type:XXX Z-Type:
XXX
Input: NOT IN WALK TEST
Figure T5
4. Use the up/down arrow keys to select the device address. When the device address is
selected, the device type, zone type and zone status will be displayed automatically.
5. Use the left/right arrow keys to move to the Walk Test status field.
6. Use the up/down arrow keys to select "NOT in Walk Test" or "In Walk Test" option.
7. Repeat steps 3 through 6 for each device to be tested.
8. When all desired devices have been selected - Press " Enter ".
9. The system will now prompt you for a signal circuit to select for Walk Test annunciation.
>> NOTE: The system will display addressable relay modules that
are not available for walk test mode.
CKT:XXX ADD:XXX D_TYPE: SIG
Output: NOT IN WALK TEST
Figure T5B
9A. Signal circuits are numbered by their physical location in the system. Use the up/down
arrows to select circuits sequentially or enter the circuit number with the alphanumeric
keypad and press enter.