IF630 Programming 5/26/01
___________________________________________________________________________________________
Rev 3.0
47
SYSTEM STARTUP
This section is subdivided into two sections, Initial System Startup and System Restart / Re-Configuration.
Instructions for a newly installed system are detailed in the Initial System Startup section. Instructions for
a "hardware reset" are detailed in the System Restart / Re-Configuration section.
CAUTION !
Connect primary power to the system before connecting
battery/standby power source.
Û
NOTE: It is assumed all system installation wiring procedures
detailed in this manual have been completed in accordance with
local, state and federal codes.
Initial System Startup
1. Activate main power. The "Power ON" message (Figure 2) is displayed. Power will now be
applied to all modules and devices.
Power ON / Hardware Reset
Please Wait ...
Figure 2
2. Wait the required 15 seconds. [Power ON] LED is flashing. Commencing System Reset screen is
displayed (see Figure 2A).
Status: RESET
00/00/94 00:00
Commencing System Reset
Figure 2A
3. To modify the program, proceed to
Password Entry - Access Levels
section.
____________________________________________________________________________________________
Summary of Contents for Smart Start IDENTIFLEX 630
