III. PREPARATION FOR USE
Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers
or paper from the appliance. We recommend washing the glass container before using it
for the first time. The knife section is treated with oil not harmful to health for technological
reasons. Therefore first fill in the container with warm water (max. 50 °C) with a small
amount of detergent. Then put the container on the food processor, set the maximum
rotational speed and run for 1 minute. Then rinse the container with clear water. Put the
blender with the selected accessories on a flat, stable, smooth and clean work surface
at the height of at least 85 cm, out of reach of children and incapacitated people. Make
sure that the power cord is not damaged and that it does not lead through any sharp or
hot surfaces. Plug power supply fork
A3
to the electric power. Choose the amount of the
processed food so that the maximum volume of the containers marked with the gauge line
is not exceeded. Possible short-time mild smoke when the appliance is operated for the
first time is not a defect and the appliance is not subject to a complaint for this reason.
Appliance assembling
(Fig. 1)
Please assemble the appliance according to Fig. 1. If you properly put the container
C
on
the driver unit, the safety clutch will be released, and you can start using the appliance.
Insert the cap
D1
or stamper
E
in the lid opening. Apply the reverse procedure to dismantle.
CONTROL:
1) Zpuštění do pohotovostního režimu
-
Connect driver unit
A
to the mains.
-
Put the container
C
on the arrest pins.
-
After placing the container in the right place, the display and all lights on the operating
board go on for a short time (a short acoustic signal can be heard). The appliance
turns on when the
B8
button is pushed (the acoustic signal can be heard again).
-
Then the individual functions may be set.
2) Manual speed setting and time setting
-
Speed can be adjusted by
B2
and
B3
buttons. 9 speed levels are available.
-
Time can be adjusted by
B4
and
B5
buttons. The processing time may be set in the
interval from 5 seconds to 6 minutes.
-
Now turn on the mixer by
B7
button.
Notes
–
B2
and
B3
buttons can be operated by short pressing.
–
B4
and
B5
button can be operated by short pressing or longer holding of the respective
button.
– Each press of
B2
,
B3
,
B4
and
B5
button is indicated by a sound signal.
–
Time adjustment step is 5 seconds.
3) Use of pre-set programmes
-
Select the required processing programme by
B9
–
B14
buttons. After you press the
respective button, a signal will sound, and the selected button‘s backlight will flash.
-
The selected processing programme may be started by pressing
B7
button.
-
The individual phases of the pre-set programmes are indicated on
B1
display.
42 / 61
