SER
VICING
55
PULSE Installation, Commissioning and Servicing Manual - Revision 19
1
GENERAL CARE AND MAINTENANCE
Gallagher dispensers are designed to give many years of reliable service. However, a
regular maintenance and servicing regime will maximise the life expectancy and reliability
of your Gallagher dispenser. The following list is the minimum routine recommended by
Gallagher for compliance with the terms of the product warranty.
1.1 Daily Maintenance
Clean all panels using a soft non-abrasive brush or cloth and a mild household detergent.
Rinse off with clean, fresh water and dry off with a soft cloth.
Never
use steel wool.
Do not use a hose as water may enter the pump electronics and adversely affect operation.
1.2 Monthly Maintenance
1. Remove any product staining on the nozzle holsters by scrubbing with a stiff nylon
brush, such as a nailbrush, using a mild household detergent and warm water.
Never
use steel wool.
2. If the use of stronger cleaning materials is required, then the following can be
used safely on panels: Methylated Spirits, Ethyl Alcohol or lsopropanol rinsed off
immediately with clean, fresh water.
3. In addition to the steps listed above, regular and prolonged contact with oil and
petrol can cause damage to powder coating. Any petrol or oil spills should be
cleaned off immediately as they are found.
4. Apply a light lubricating oil to hose swivels and other moving parts. Remove excess
with a cloth. Aerosol type products such as CRC or WD40 are an excellent choice
for this task.
5. Apply a silicone based polish to all exterior panels. There are many suitable domestic
and automotive polishes available — do not use products containing abrasives.
6. Note any damage to paintwork and have this repaired.
7. Inspect nozzles for signs of damage and wear and tear.
8. Check hoses for signs of wear and tear or damage (e.g. abrasions, bulges, distortion,
etc.) and replace any exhibiting such signs. Hoses should not touch the ground
when the nozzle is holstered correctly. Adjust the clamp of any which touch the
ground, and replace any hoses which have stretched beyond the adjustment limit.
1.3 Annual Maintenance
In addition to regular monthly maintenance include the following:
1. Check the hydraulic components of Gallagher dispensers for correct operation.
2. Check the tension of pump vee-belts. Replace any that have excess play or are
showing signs of wear or damage.
3. If replacing gaskets on flanged joints, M8 bolts/nuts must be tightened to a target
torque for the gasket being replaced. These are shown on the following page.
4. Inspect internal hoses and pipework joints/connections for evidence of leaks.
5. Check and confirm the integrity of all fixings and mounting bolts.
