Gage CompuScope 14100C, Hardware Manual And Driver Installation Manual

Page: 96 / 174

90 CompuScope 82GC
Absolute Maximum Amplitude:
1
M
Ω
: ±15 Volts (continuous)
50
Ω
: ±5 Volts (continuous)
DC Accuracy relative to full scale input:
All ranges: ±2% of full scale
Sampling Rate
Single-Channel Mode (Channel 1 only)
GS/s: 2, 1
MS/s: 500, 250, 200, 100, 40, 20
Dual-Channel Mode (Channels 1 and 2 simultaneously)
GS/s:
1
MS/s: 500, 250, 125, 100, 50, 20, 10, 5, 2, 1
kS/s: 500, 200, 100
†
Input Protection
1 M
Ω
impedance: Diode Clamped
50
Ω
impedance: No protection
Connector: BNC
†
DYNAMIC PARAMETERS
Measured using a sine wave input at 1 GS/s, dual channel mode with amplitude of 95% of full scale on the ±1 V
range with a 50
Ω
input. Typical values are listed below.
10 MHz Input 100 MHz Input
SNR 45 dB 43 dB
SFDR 54 dB 50 dB
SINAD 44 dB 42 dB
THD -52 dB -48 dB
ENOB 7.2 bits 6.85 bits
ACQUISITION MEMORY
Data Storage: In on-board memory
Memory sizes: 2 M, 8M, 16M (8 bit samples)
Maximum memory depth:
Single Channel Mode: Up to full on-board memory
Dual Channel Mode: Up to half on-board memory per channel
†
TRIGGERING
Number of Trigger Inputs: 1 per system
Trigger Source:
CH 1, CH 2, EXT or Software
Type: Analog triggering
Sensitivity: ± 10% of full scale
Level Accuracy: ± 5% of full scale
Slope: Positive or Negative, software selectable
Post Trigger Data: 256 (512) points minimum.
Can be defined with a 128 (256) point resolution in dual (single) channel mode