Gage CompuScope 14100C, Hardware Manual And Driver Installation Manual

Page: 129 / 174

CompuScope 14100C 123
•
Master/Slave connector is located on the front panel. This connector is used to pass Clock, Trigger
and Initialization signals from a Master card to Slave card(s) using a Master/Slave Timing Module.
•
Trigger Out BNC connector is located on the front panel near the bottom of the card. This connector
outputs a TTL signal, the low to high transition of which signifies the occurrence of a trigger event on
the CS14100C. See the section
CompuScope 14100C Trigger Output for more details.
•
CompactPCI
TM
connector is located at the rear of the card. This is an industry standard connector
that complies with all specifications of the CompactPCI
TM
bus.
•
Status LEDs are located at the bottom of the front panel. Note that the BUSY LED is illuminated
when the CompuScope 14100C is capturing a signal. The TRIG LED is illuminated after the
CompuScope 14100C receives a trigger.