Zennio Lumento DX4, Technical Documentation

Page: 1 / 2

© Zennio Avance y Tecnología S.L. Edition 6 Further information www.zennio.com Page 1/2
Lumento DX4
4-channel constant voltage PWM dimmer in DIN rail for DC LED loads with 6 binary/analogue inputs
ZDI-RGBDX4 TECHNICAL DOCUMENTATION
FEATURES
•
4 constant voltage channels configurables (independent channels,
RGBW channels and RGB+W channels).
•
6 analog/digital inputs.
•
Master Light control.
•
External 12-30VDC power supply.
•
Manual output operation with push button and LED status indicator.
•
Total data saving on KNX bus failure.
•
Integrated KNX BCU.
•
Dimensions 60 x 90 x 79mm (4,5 DIN units).
•
DIN rail mounting (EN 50022), through pressure.
•
Conformity with the CE directives (CE-mark on the right side).
Figure 1: Lumento DX4
Programming/Test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual mode
is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash. A blue blink
represents an error.
GENERAL SPECIFICATIONS
CONCEPT DESCRIPTION
Type of device Electric operation control device
KNX supply
Voltage (typical) 29VDC SELV
Voltage range 21..31VDC
Maximum
consumption
Voltage mA mW
29VDC (typical) 6.5 188.5
24VDC¹ 10 240
Connection type Typical TP1 bus connector for 0.80mm Ø rigid cable
External power supply 12-30VDC
Operation temperature 0°C .. +55°C
Storage temperature -20°C .. +55°C
Operation humidity 5 .. 95%
Storage humidity 5 .. 95%
Complementary characteristics Class B
Protection class III
Operation type Continuous operation
Device action type Type 1
Electrical stress period Long
Degree of protection IP20, clean environment
Installation
Independent device to be mounted inside electrical panels with DIN rail (EN
50022)
Minimum clearances Not required
Response on KNX bus failure Data saving according to parameterization
Response on KNX bus restart Data recovery according to parameterization
Operation indicator
The programming LED indicates programming mode (red), test mode
(green) and error (blue blinking). Colour shift LEDs show the current colour.
Each output LED indicates its status.
Weight 184g
PCB CTI index 175V
Housing material PC FR V0 halogen free
¹ Maximum consumption in the worst-case scenario (KNX Fan-In model)
3
10
7
9
2
8
1
5
4
6
6
1 . External power supply 2 . Colour shift status LED* 3 . Colour shift control buttons* 4 . Channel control button 5 . Channel status LED
6 . Output channels 7 . KNX connector 8 . Programming/Test LED 9 . Programming/Test button 10 . Inputs