© Fulton Group N.A., Inc. 2020
6-4
EXPORTING DATA USING FILE MANAGER
Hydronic-PURE-Control-UserManual-211214
SECTION 6
!
WARNING
This addendum is specific to the usage
of the
Hydronic PURE Control™
and
should be used in conjunction with
the current version of the respective
boiler’s Installation and Operation
manual. Both should be read in their
entirety and be made permanently
available to the staff responsible for
equipment operation.
This addendum should not be
considered as a complete guide, nor
should it replace existing guides or
standards which may be applicable.
Fulton reserves the right to change
any part of this addendum and
the corresponding Installation and
Operation manual without notice.
Do not install, operate, service
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this addendum is
for reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes or
regulations.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas
supplier from a neighbor’s phone.
• Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
A qualified installer, service agency
or the gas supplier, must perform
installation and service.
Taking a Screenshot
Perform the following steps:
1. At any screen, press and hold the top right corner of the screen until a
drop-down menu appears.
2. Click on
Screenshot
.
3. It is also possible to take a screenshot of a trending graph.
» Navigate to the Trending screen.
» On the top right of the graph, click on the icon of a camera.
» The graph screenshot will be located with the rest of the screenshots
on the PLC.
» Clicking on
Next Curve
at the bottom of the screen will allow you to
cycle between the seven different graphs. There are graphs available
for inlet, outlet and combustion air temperatures, current setpoint,
dry O
2 and firing rate.
