© Fulton Group N.A., Inc. 2020
3-16
CONTROL MENUS
Hydronic-PURE-Control-UserManual-211214
SECTION 3
!
WARNING
This addendum is specific to the usage
of the
Hydronic PURE Control™
and
should be used in conjunction with
the current version of the respective
boiler’s Installation and Operation
manual. Both should be read in their
entirety and be made permanently
available to the staff responsible for
equipment operation.
This addendum should not be
considered as a complete guide, nor
should it replace existing guides or
standards which may be applicable.
Fulton reserves the right to change
any part of this addendum and
the corresponding Installation and
Operation manual without notice.
Do not install, operate, service
or repair any component of this
equipment unless you are qualified
and fully understand all requirements
and procedures.
All information in this addendum is
for reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes or
regulations.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas
supplier from a neighbor’s phone.
• Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
A qualified installer, service agency
or the gas supplier, must perform
installation and service.
Primary (Boiler) Pump Control
The
Primary Circulation Pump
screen is only selectable when the feature has
been enabled from the
Auxiliary Configuration
section under
Admin
. This
screen will allow control of a dedicated boiler pump (primary pump) to best
accommodate a primary/secondary piping arrangement.
