102
Chapter 3 OS Installation Using ServerStart
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" (
pg.125) and perform necessary procedures
before starting server operations.
●
In Preconfiguration Mode
1
Create a configuration file.
For the creation procedure, refer to "3.2 Preconfiguration Mode" (
Specify the shared name of the prepared shared folder instead of the local CD-ROM as instal-
lation source information.
2
Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
3
Set the created configuration file and click [OK].
The [ServerStart Unattended Mode] window appears.
4
Click [Start].
Installation starts. At steps where the CD-ROM for resources such as the OS to be installed is
necessary, the resource is automatically acquired from the resource server via the network.
5
Eject the CD-ROM and floppy disk and click [OK].
The system restarts. When the installation is completed, an installation completion message
appears on the target server.
6
Press any key on the target server.
7
Restart the system on the target server.
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" (
pg.125) and perform necessary procedures
before starting server operations.
Summary of Contents for Primergy RX100 S2
