![background image](http://html1.mh-extra.com/html/intesisbox/modbus-server-fc330a/modbus-server-fc330a_installation-manual_2081035001.webp)
IntesisBox
®
Modbus Server – FC330A
Doc. Rev. 2
Installation Manual
URL
tel
http://www.intesis.com
[email protected]
+34 938047134
1 / 5
This information is subject to change without notice.
•
IntesisBox must be installed by accredited electrician or similar technical personnel, following all the safety instructions
given here, and in accordance always with the country legislation for installation of electric equipment.
•
IntesisBox can not be installed outdoors or exposed to direct solar radiation, water, high relative humidity or dust.
•
IntesisBox must only be installed in a restricted access location
•
In case of wall mount, fix firmly IntesisBox on a not vibrating surface following the instructions below.
•
In case of DIN rail mount fix IntesisBox properly to the DIN rail following the instructions below.
•
Mounting on DIN rail inside a metallic cabinet properly connected to earth is recommended.
•
Disconnect always power of any wires before manipulating and connecting them to IntesisBox.
•
A power supply with an NEC Class 2 or Limited Power Source (LPS) and SELV rated is to be used.
•
Respect always the expected polarity of power and communication cables when connecting them to IntesisBox.
•
Supply always a correct voltage to power IntesisBox, see details of voltage range admitted by the device in the technical
characteristics below.
•
This device was designed for installation in an enclosure. To avoid electrostatic discharge to the unit in environments with
static levels above 4 kV precautions should be taken when the device is mounted outside an enclosure. When working in
an enclosure (ex. making adjustments, setting switches etc.) typical anti-static precautions should be observed before
touching the unit
Safety Instructions
WARNING
Follow carefully this safety and installation instructions. Improper work may lead to serious harmful for your
health and also may damage seriously the IntesisBox and/or any other equipment connected to it.
Use the software LinkBoxMB to configure IntesisBox, follow the instructions of the user's manual for more
details.
See instructions to download and install the latest version of LinkBoxMB and
the user's manual at
http://www.intesis.com/down/mb/linkboxmb.html
Configuration and setup
•
Disconnect from mains the power supply before connecting it to IntesisBox.
•
Disconnect power of any bus or communication cable before connecting it to IntesisBox.
•
Mount IntesisBox on the wall or DIN rail following the instruction given below, respecting the safety
instructions given above.
•
Connect a NEC Class 2 or Limited Power Source (LPS) and SELV rated power supply to IntesisBox,
respect the polarity if DC power or Line and Neutral if AC power. Apply always a voltage within the range
admitted by IntesisBox and of enough power (see technical characteristics).
•
Circuit-breaker must be used before the power supply. Rating 250V-6A
•
Connect the communication cables to IntesisBox, see details on the user's manual.
•
Power IntesisBox and the rest of devices connected to it.
Installation instructions