Fujitsu Oracle M10-1, Service Manual

Page: 129 / 254

Table 7-14 System-stopped/hot removal work procedure (for an internal disk)
Item Work procedure Reference
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
" 5.2 Switching the Mode Switch to Service Mode "
3 Checking the operating condition
of the system and the I/O device
usage status
" 5.3 Checking the Operating Condition and Resource Usage Status "
4 Stopping the system " 5.5 Stopping the Entire System "
5 Removing an internal disk " Chapter 9 Maintaining the Internal Disks "
6 Diagnosing the chassis requiring
maintenance
" 6.4 Diagnosing a Replacement FRU "
7 Confirming that there is no
problem with the chassis after the
removal
" 6.7 Checking the FRU Status after Maintenance "
8 Returning the mode switch on the
operation panel to Locked mode
" 6.8 Returning the Mode Switch to Locked Mode "
9 Starting the system " 6.9 Starting the System "
10 Closing the rack door
Note -
If the memory configuration is changed when a logical domain is used in a configuration
other than factory-default, the system may start in the factory-default state of the logical
domain configuration of the physical partition. In this case, the OpenBoot PROM environment
variables of the control domain will be initialized too.
To prepare for this possibility, record the configuration information for the OpenBoot PROM
environment variables in the control domain before removing memory. After you remove
memory, if the logical domain configuration of the physical partition enters the factory-
default state, set the OpenBoot PROM environment variables and logical domain configuration
again by referring to the recorded information.
System-stopped/cold removal (for memory)
System-stopped/cold removal can be performed on memory. Perform removal
according to the following procedure.
Chapter 7 Maintenance Flow 115