Fujitsu Oracle M10-1, Service Manual

Page: 72 / 254

2 /FAN#1 Normal
3 /FAN#2 Normal
4 /FAN#3 Normal
5 /FAN#4 Normal
6 /FAN#5 Normal
7 /FAN#6 Faulted
------------------------------------------------------------------------------
Select [1-7|b:back] : 7
You are about to replace FAN#6.
Do you want to continue?[r:replace|c:cancel] :
r
Please execute the following steps:
1) Confirm the Check LED is blinking.
2) Remove FAN#6.
3) Execute either the following:
3-1) After installing the exchanged device, please select 'finish'.
3-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
5. After confirming that the selected FRU is displayed, enter [r].
6. Confirm that the CHECK LED of the FRU is blinking.
For the CHECK LED location, see " 2.4.3 LEDs on each component ."
You can now start FRU maintenance. Do not enter "f" until you complete the
maintenance work.
After replacing the FRU, perform the work in " 6.2 Incorporating a FRU into the
System with the replacefru Command " to incorporate the FRU into the system.
5.8 Accessing a FRU
This section describes the operations to be performed before accessing the FRU
requiring maintenance. The required operations vary depending on the FRU
requiring maintenance.
5.8.1 Removing the power cords
Remove the cable clamp from each power cord, and then remove the power cords.
1. Release the latch (A in Figure 5-1 ) of the cable clamp.
Pulling the cable clamp toward the rear of the chassis facilitates the release of the
latch.
Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021 58