Fujitsu Oracle M10-1, Service Manual

Page: 97 / 254

primary#
ldm list-domain
primary#
svccfg -s ldmd setprop ldmd/recovery_mode = astring: never
primary#
svcadm refresh ldmd
primary# svccfg -s ldmd listprop ldmd/recovery_mode
ldmd/recovery_mode astring never
primary#
ldm list-config | grep "factory-default"
factory-default [current]
primary# ldm set-spconfig factory-default
XSCF> poweroff -p ppar_id
3.
If you need to disable recovery mode, disable it.
a. Use the svccfg command and svcadm command to disable recovery mode.
b. Confirm that recovery mode is disabled.
6.5.3 Restoring the logical domain configuration
information and OpenBoot PROM environment
variables
Reflect the setting of the XML file saved in " 5.6.3 Saving the logical domain
configuration information and OpenBoot PROM environment variables ," and execute
the shutdown command and restart the control domain.
The following shows the procedure for restoring the saved configuration information
of the logical domains.
1. Confirm that the current logical domain configuration is factory-default.
If [current] does not appear beside "factory-default," the current logical domain
configuration is not factory-default. In such a case, follow the procedure below
to change the current logical domain configuration to factory-default.
a. Execute the ldm set-spconfig command with "factory-default" specified.
b. Execute the poweroff command of the XSCF firmware and turn off the power
to the physical partition.
2. The OpenBoot PROM environment variables are initialized. So, reset it to the
original values.
Chapter 6 Understanding the Preparations for Restoring the System 83