Fujitsu Oracle M10-1, Service Manual

Page: 98 / 254

XSCF>
setpparparam -p 0 -s bootscript "setenv auto-boot? false"
PPAR-ID of PPARs that will be affected:0
OpenBoot PROM variable bootscript will be changed.
Continue? [y|n] :
y
XSCF>
showpparparam -p 0
use-nvramrc :-
security-mode :-
bootscript :
setenv auto-boot? false
XSCF>
poweron -p 0
XSCF>
showdomainstatus -p 0
Logical Domain Name Status
primary OpenBoot Running
XSCF> console -p 0 -y
Console contents may be logged.
Connect to PPAR-ID 0?[y|n] :
y
{0} ok
setenv boot-device /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@
p0,0
boot-device = /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0,0
{0} ok
printenv boot-device
boot-device = /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0,0
a. To stop in the OpenBoot PROM state, confirm "auto-boot?" out of the
OpenBoot PROM environment variables.
If the value is "true", change it to "false".
b. If you change the setting, confirm the OpenBoot PROM environment variables.
c. Execute the poweron command to restart the physical partition.
d. Execute the showdomainstatus command to check the status of the control
domain.
Confirm that the status of the control domain is displayed as "OpenBoot
Running" indicating that it is in the OpenBoot PROM state.
e. Execute the console command to switch to the control domain console.
f. Restore the OpenBoot PROM environment variables based on the record
saved in " 5.6.3 Saving the logical domain configuration information and
OpenBoot PROM environment variables ."
The following example restores the boot-device to "/pci@8000/pci@4/pci@0/
pci@0/scsi@0/disk@p0,0".
Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021 84