Fujitsu Oracle M10-1, Service Manual

Page: 41 / 254

Table 3-3 Whether system-stopped maintenance (inactive maintenance) (replacement/
addition/removal) is enabled for each FRU
-: Maintenance cannot be performed.
FRU System-stopped
(inactive)
/hot maintenance
System-stopped
(inactive)
/cold maintenance
Reference
PCIe card - (*1) OK Chapter 8
Internal disk OK OK Chapter 9
HDD backplane - OK Chapter 10
Power supply unit OK (*2) OK Chapter 11
PSU backplane - OK Chapter 12
Cable kit - OK Chapter 13
Operation panel - OK Chapter 14
Fan unit OK OK Chapter 15
Motherboard unit - OK Chapter 16
Memory - OK Chapter 16
*1 System-stopped (inactive)/hot maintenance can be performed on the PCIe cards mounted in the PCI expansion
unit. For details, see "3.3 Types of Maintenance for the PCIe Card" in the PCI Expansion Unit for Fujitsu SPARC
M12 and Fujitsu M10/SPARC M10 Service Manual .
*2 If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the replacefru command.
Perform system-stopped (inactive)/cold maintenance.
3.3 System-stopped Maintenance
(Inactive Maintenance)
The type of maintenance performed with the physical partition stopped is referred to
as system-stopped maintenance (inactive maintenance). SPARC M10-1 has the only
one physical partition. Thus, the state in which the physical partition requiring
maintenance is stopped is the same as the state in which the entire system is stopped.
Table 3-3 shows whether system-stopped maintenance (inactive maintenance) is
enabled for each FRU.
Chapter 3 Types of Maintenance 27