Fujitsu Oracle M10-1, Service Manual

Page: 101 / 254

c2::smp/expd0 smp connected configured unknown
c3 scsi-sas connected unconfigured unknown
c4 scsi-sas connected unconfigured unknown
c5 fc connected unconfigured unknown
c6 fc connected unconfigured unknown
c7 scsi-sas connected unconfigured unknown
<Omitted>
# cfgadm -c configure Ap_Id
# cfgadm -x led=fault,mode=off Ap_Id
# svcadm disable hotplug
XSCF>
showstatus
4.
If the system does not recognize the incorporated internal disk, make it
recognized in the system.
a. Execute the cfgadm -c configure command to incorporate the target internal
disk into the logical domain.
b. With the cfgadm -al command, check the status of the internal disk.
5. If the CHECK LED on the mounted internal disk is not off, execute the cfgadm
-x command to turn off the CHECK LED on that internal disk.
6. If you have enabled the hotplug service, execute the svcadm disable
command to disable the hotplug service.
7. Assign the I/O device of the incorporated internal disk to the logical domain.
To configure the hardware RAID by adding a new internal disk, see "14.2
Configuring Hardware RAID" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC
M10 System Operation and Administration Guide .
6.7 Checking the FRU Status after
Maintenance
This section describes the procedure for confirming that the FRU is operating
normally after the completion of maintenance.
1. Log in to the XSCF shell.
2.
Execute the showstatus command.
Nothing is displayed in the normal state.
Chapter 6 Understanding the Preparations for Restoring the System 87