Fujitsu Oracle M10-1, Service Manual

Page: 66 / 254

#
cfgadm -a
#
cfgadm -x led=fault,mode=blink Ap_ID
Note - Before stopping the system, inform the users that the system will be stopped.
Note - When a physical partition is stopped by the operation of the XSCF command or the
operation panel, all the logical domains on the physical partition are stopped. Stop
applications as required.
XSCF>
poweroff -a
PPAR-IDs to power off:00
Continue? [y|n] :
y
5.
Execute the cfgadm command to blink the CHECK LED of the internal disk
requiring maintenance, and determine its location.
Enter the Ap_ID you noted in advance.
6. Check the following LEDs to determine whether the internal disk requiring
maintenance can be removed:
- READY LED (green) of the internal disk: On
- CHECK LED (amber) of the internal disk: Blinking
5.5 Stopping the Entire System
This section describes the procedure for stopping the entire system.
Stop the system in either of the following two ways.
■
Stopping the system with the XSCF command
■
Stopping the system from the operation panel
5.5.1 Stopping the system with the XSCF command
1. Confirm that the mode switch on the operation panel is in Service mode.
2. Log in to the XSCF shell.
3.
Execute the poweroff command.
Enter "y" in response to the confirmation message.
In the following example, the displayed status of PPAR-ID 00 is "Powering off,"
so you can see that the power-off instruction for the physical partition completed
successfully.
Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021 52