Fujitsu Eternus web GUI, User Manual

Page: 32 / 635

Chapter 3 Initial Setup
3.1 Initial Setup 1
ETERNUS Web GUI User’s Guide
32
Copyright 2011 FUJITSU LIMITED P2X0-1090-02ENZ0
3.1 Initial Setup 1
The flow of wizard operations in Initial Setup 1 is shown below.
(1) Set Storage Name
Register the name, administrator, and installation site of the ETERNUS DX Disk storage
system. Refer to
"11.2.9.1 Modify Storage Name" (page 576) for details.
(2) Set Date and Time
Set the date/time and time zone (device location) of the internal clock in the ETERNUS DX
Disk storage system. Refer to
"11.2.9.2 Modify Date and Time" (page 577) for details.
(3) Change Password
Change the password for the default account that is currently logged in before starting to use
the ETERNUS DX Disk storage system. Refer to
"11.2.1 Change User Password" (page 455)
for details.
(4) Register Thin Provisioning License
If using the Thin Provisioning function, register the license here. Refer to "7.2.9 Register Thin
Provisioning License" (page 168) for details.
(5) Register Copy License
If using the Advanced Copy function, register the license here. Refer to "8.2.3 Register
Advanced Copy License" (page 202) for details.
(6) Register SED Authentication Key
Register the SED Authentication Key to enable encryption of the SEDs. Refer to "11.2.9.7
Register SED Authentication Key" (page 588) for details.
(7) Set Network Environment
Set the environment for the ETERNUS DX Disk storage system to communicate on the
network such as IP address and subnet mask. Refer to
"11.2.3.1 Setup Network
Environment" (page 458) for details.
Log out when the settings are complete. Log in again, and then proceed to "3.2 Initial Setup 2"
(page 42) .
If SED has been installed before registering the SED authentication key, reboot the ETERNUS
DX Disk storage system before logging in again.