FujiFilm PXG4, Operation Manuals

Page: 98 / 158

– 97 –
9
Chapter
●
Ramp soak delay start
●
Break/Short-Circuit Alarm
●
Condition Output
Setting DO Option Functions
The following steps explain how to set Do event types by
using absolute upper limit alarm as an example.
Class
DO
1 to 5
Function
Ramp
soak delay
start 35 Delay start ON
Class
DO
1 to 5
Function
Break/
Short-Circuit
Warning 41
44
47 Loop break alarm
Heater break alarm
Load short-circuit alarm
Class
DO
1 to 5
Function
Condition Output 51
52
53
54
55
56 During auto-tuning
Normal Operation
Standby
Manual Mode operating
Remote SV operating
During ramp SV
Ramp/Soak
Event Output 60
61
62
63
65 OFF state
RUN state
HOLD state
GS (guaranteed soale) state
END state
Time
Signal 71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102 Time signal (1st segment)
Time signal (2nd segment)
Time signal (3rd segment)
Time signal (4th segment)
Time signal (5th segment)
Time signal (6th segment)
Time signal (7th segment)
Time signal (8th segment)
Time signal (9th segment)
Time signal (10th segment)
Time signal (11th segment)
Time signal (12th segment)
Time signal (13th segment)
Time signal (14th segment)
Time signal (15th segment)
Time signal (16th segment)
Time signal (17th segment)
Time signal (18th segment)
Time signal (19th segment)
Time signal (10th segment)
Time signal (21st segment)
Time signal (22nd segment)
Time signal (23rd segment)
Time signal (24th segment)
Time signal (25th segment)
Time signal (26th segment)
Time signal (27th segment)
Time signal (28th segment)
Time signal (29th segment)
Time signal (30th segment)
Time signal (31st segment)
Time signal (32nd segment)
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh1111
"), then use the
keys to display SYS ("
SSS
SYYYYSSSS CCCChhhh 7777
").
Refer to
See p. 93 in this chapter for information on how to display
the channel menu.
2
Press and hold the key, then use the
keys to display do1T ("
ddd
doooo1111TTTT
").
3
Press the key, then use the keys to
select 1 when the bottom part of the display
begins to blink.
DO1 is set to absolute upper limit alarm.
4
Press the key to confirm the setting.
5
Repeat steps 2 to 4 (excluding pressing and
holding the key) to set other DO functions.
6
Press the key to return to the operation mode
PV/SV display.