FujiFilm PXG4, Operation Manuals

Page: 143 / 158

– 142 –
15
Chapter
Overview of Environmental Parameters (Ch13)
This section covers the operating environment parameters for this device.
Display Parameter name Function Setting range
Initial
value
Remarks
"
TTT TooooUUUUTTTT
" (ToUT) Display Timeout Setting Specifies the time after which
the setting display returns to the
PV/SV display. 15S: 15 sec 60S 143
30s: 30 sec
60s: 60 sec
5M: 5 min
10M: 10 min
non
"
rrr r----FFFFkkkk
" (r-Fk) Remote SV Display Blink
Setting Specifies whether the SV
display blinks when in remote
mode. oFF: OFF on 144
on : ON
"
SSS SooooFFFFkkkk
" (SoFk) Soft Start SV Display Blink
Settings Specifies whether the SV
display blinks during soft start. oFF: OFF on 144
on : ON
"
AAA ALLLLMMMMFFFF
" (ALMF) ALM PV/SV Display Blink Specifies whether the PV/SV
display blinks when DO turns
ON. 0 145
"
bbb bCCCCoooonnnn
" (bCon) Burnout control selection Sets whether to maintain or stop
the control when the PV input
burnout is detected. on : Continuous control
oFF : Stop control oFF 146
"
PPP PTTTTnnnnTTTT
" (PTnT) Ramp soak pattern order Changes the ramp soak pattern
order. 0:
(normal order)
1:
(special order)
0 147
"
LLL L----CCCC2222
" (L-C2) C2 LED lamp function
allocation Sets the illumination condition
of the C2 lamp. 0: MV2 output/CLOSE output
(lights/blinks, but the AO output
does not function.)
1: during manual mode
2: during standby
3: during remote SV mode
4: no function (do not set)
5: during soft start
6: during ramp SV
7: during ramp/soak
8: during SV selection
(when other than front SV is
selected)
9: during PID selection
(when PID other than Pid
channel is selected)
10:during auto-tuning
0 148
"
rrr rSSSSTTTT
" (rST) Main Unit Reset Main Unit Reset oFF: Do nothing oFF 149
rST: Reset main unit
Setting display 0 to 255 (decimal)
Setting (binary)
1: blinking (DO1: ON)
0: no blinking
1: blinking (DO2: ON)
0: no blinking
1: blinking (DO3: ON)
0: no blinking
1: blinking (DO4: ON)
0: no blinking
1: blinking (DO5: ON)
0: no blinking