FujiFilm PXG4, Operation Manuals

Page: 84 / 158

– 83 –
8
Chapter
OUT1 Range ,
OUT2 Range
Specifies the range for control output (OUT1/OUT2)
• Range 0-5 : 0V to 5V
1-5 : 1V to 5V
0-10 : 0mA to 10V
2-10 : 2V to 10V
0-20 : 0mA to 20mA
4-20 : 4mA to 20mA
Setting the OUT1/OUT2 Range
The following steps explain how to set OUT1 range by using
0mA to 20mA as an example.
Caution
Do not use 0-5, 1-5, 0-10, or 2-10 if current is selected for output 1
and output 2 in the model specifications. Do not use 0-20 or 4-20
if voltage is selected for output 1 and output 2.
The unit will not operate properly if improper settings are
chosen.
1
Press and hold the key to display the setup
mode channel menu ("
ooo
oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to select C1r ("
CCC C1111rrrr
").
3
Press the key, then use the keys to
select 0-20 when the bottom part of the display
begins to blink.
The OUT1 range is set to 0mA to 20mA.
4
Press the key to confirm the setting.
5
Repeat steps 2-4 (excluding pressing and holding
the key) to set FALT OUT2.
6
Press the key to return to the operation
mode PV/SV display.
FALT OUT1 Value ,
FALT OUT2 Value
This is the procedure for specifying the output value of
OUT1/OUT2 should this device fall go into the FALT state
(Input Error).
• Range: -3.0% to 103.0% (OUT1/OUT2)
Setting FALT OUT1/OUT2
The following steps explain how to set the FALT OUT1/OUT2
setting by using 5% as an example.
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS
SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to select Flo1 ("
FFF Flllloooo1111
").
3
Press the key, then use the keys to
select 5.0 when the bottom part of the display
begins to blink.
OUT1 output is set to 5.0%.
4
Press the key to confirm the setting.
5
Repeat steps 2-4 (excluding pressing and holding
the key) to set FALT OUT2.
6
Press the key to return to the operation
mode PV/SV display.