FujiFilm PXG4, Operation Manuals

Page: 15 / 158

– 14 –
2
Chapter
Parameter Overview
The parameters are divided into 13 channels. Each channel contains one series of parameters. Refer to the following
chapter for a detailed explanation of each channel. The following is an overview of the channels.
●
Setup Mode — Channel Menu
Channel Display Parameter Name Overview Page
Ch 1
oPE
Operation Sets the parameters for operation. 21
Ch 2
Pid
Control (PID) Sets the parameters concerning controls. 29
Ch 3
PLT
PID Palette Sets the PID palette 1 to 7. 43
Ch 4
PrG
Ramp/Soak Sets the parameters concerning ramp/soak. 53
Ch 5
Mon
Monitor Allows you to confirm the status of the controller by checking each value.
(Cannot be set.) 63
Ch 6
SET
Setup Sets the parameters concerning input/output. 71
Ch 7
SyS
System Sets the parameters concerning system definitions for the controller. 89
Ch 8
ALM
Alarm Sets the parameters concerning the alarm function. 111
Ch 9
CoM
Communication Sets communication parameters such as the communication station number. 119
Ch10
PFb
Position Feedback
(PFB) Sets the parameters for motorized valve control. 125
Ch11
PAS
Password Setup Controls password settings 131
Ch12
dSP
Display Mask for Each
Parameter Sets which parameters are displayed depending on the set value. 133
Ch13
CFG
Environmental
Parameters(Config) Sets the parameters concerning setup definitions for the controller. 141
Monitor Mode
Operation Ramp/Soak Monitor PID PID palette
Setup Communication PFB System Alarm
hold down
Password Display Configuration