FujiFilm PXG4, Operation Manuals

Page: 83 / 158

– 82 –
8
Chapter
Remote SV Input Filter
This low-pass filter function reduces noise and signal
wavering.
• Range: 0.0 sec to 120.0 sec (input filter damping)
When the input suddenly steps from 0% to 100% with the
input filter constant set to 5 seconds, the remote SV display
will change slowly and take 5 seconds to change from 0% to
63.2%.
Setting the Remote SV Filter
The following steps explain how to set the remote SV filter by
using 10 sec as an example.
Caution
The factory setting for input filter damping is 5%. Do not
change this unless absolutely necessary.
remote SV input Y
control
output
input
filter
PID
100
63
(%)
%
input
remote SV display
t
Approx.
5 sec
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS
SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to display rTF ("
rrr rTTTTFFFF
").
3
Press the key, then use the keys to
select 10.0 when the bottom part of the display
begins to blink.
The remote SV input filter damping is set to 10.0 sec.
4
Press the key to confirm the setting.
5
Press the key to return to the operation
mode PV/SV display.