FujiFilm PXG4, Operation Manuals

Page: 149 / 158

– 148 –
15
Chapter
C2 Lamp Allocation
The C2 lamp output can be allocated to display the
following information.
Setting the C2 Lamp Allocation
This section explains how to allocate the lamp by using C2 =
Auto Tuning as an example.
Setting Conditions where C2 Lamp Blinks
0: MV2 output/CLOSE output
(lights/blinks, but the AO output
does not function.)
1: during manual mode
2: during standby
3: during remote SV mode
4: no function (do not set)
5: during soft start
6: during ramp SV
7: during ramp/soak
8: during SV selection
(when other than front SV is
selected)
9: during PID selection
(when PID other than Pid channel is
selected)
10: during auto-tuning
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display CFG ("
CCC
CFFFFGGGG CCCChhhh11113333
").
Refer to
See p. 143 in this chapter for information on how to
display the channel menu.
2
Press and hold the key, then use the
keys to select LC-2 ("
LLL LCCCC----2222
").
3
Press the key, then use the keys to
select "10" when the bottom part of the display
begins to blink.
LED C2 is allocated to Auto Tuning.
4
Press the key to confirm the setting.
5
Press the key to return to the operation mode
PV/SV display.