Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 53 / 149

-46-
4.12.1.2. Thermal range (single range)
Description
 The range (full scale) of thermal energy to be measured is set. (for 1-path/energy
measurement)
* The analog output (4-20mA) corresponds to the range setting.
 Settable range: 0.000000 to 99999999.
* THERMAL UNIT must be set beforehand.
<Note> The thermal unit is as selected by "THERMAL UNIT" in the "MEASURE
SETUP" mode. (Refer to Section 4.11.2)
For actual keying, refer to the typical operation indicated below. Set the protection to
OFF beforehand. (See Section 4.5.1)
Operation
(example) Set the range type to single range and “FS 1(THERMAL)” to thermal flow of 2000MJ/h.
* Set the piping parameters and "THERMAL UNIT" beforehand.
* Below is an example for 1-path/energy measurement.
Key operation Description Display
▼
Press the key twice to display “OUTPUT SETUP”.
OUTPUT SETUP
ENT
▼
Press the
ENT
key once to enter the “ZERO ADJUSTMENT” mode.
ZERO ADJUSTMENT
SET ZERO
▼
Press the key for 4 times to display “RANGE”.
RANGE
ENT
▼
Press the
ENT
key once to display “KIND”.
KIND
FLOW RATE
▼
Press the key once to display “RANGE TYPE”
Because single range (factory set) is already registered, go to the next
step.
RANGE TYPE
SINGLE
▼
Press the key 10 times to display “FS 1(THERMAL)”.
FS 1(THERMAL)
０ ＭＪ／ｈ
ENT
▼
Press the
ENT
key once to blink the cursor.
FS 1(THERMAL)
０ ００００００００ ＭＪ／ｈ
▼
▼
▼
▼
Move the cursor by the key, and change the numeric value by the
key.
Change the value of FS 1(THERMAL) to “20000.”
Note) To change the decimal point position, align the cursor with a
place to change to and press the key likewise.
００００ ０ ００００ ＭＪ／ｈ
００００ ２ ００００ ＭＪ／ｈ
Press the
ENT
key once to save the change.
FS 1(THERMAL)
＊＊
COMPLETE
＊＊
↓
ENT
▼
▼
▼
▼
―――
FS 1(THERMAL) has been registered.
―――
FS 1(THERMAL)
２００００ ＭＪ／ｈ
ESC
Press the
ESC
key twice and the key 3 times to return to the
measurement mode.
０．０００ ｍ／ｓ
０．０００ ｍ３／ｈ
20mA
4mA
0 100%
流量
Thermal energy
Full scale