Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 28 / 149

-21-
4.3.2. 2-pipe mode
Measurement mode
PAR.PROTECTION PROTECTION ON INPUT ID NO.
PROTECTION OFF
OUTPUT SETUP ZERO ADJUSTMENT
CH1
Clear or set zero
CH2
CH ALL
DAMPING CH1
CH2
CH ALL
( 㪘㪻㫁㫌㫊㫋㩷㪚㪟㪈㩷㪸㫅㪻㩷㪚㪟㪉㩷㫊㫀㫄㫌㫃㫋㪸㫅㪼㫆㫌㫊㫃㫐㪅 )
( 㪪㪼㫋㩷㫋㪿㪼㩷㫊㪸㫄㪼㩷㫍㪸㫃㫌㪼㫊㩷㪽㫆㫉㩷㪚㪟㪈㩷㪸㫅㪻㩷㪚㪟㪉㪅 )
CUTOFF CH1
CH2
DISPLAY 1ST.ROW CH1 Select which measured value (flow rate, velocity, totalized, etc) to be displayed on Display 1.
CH2
CH3
2ND.ROW (Same as "1ST")
RANGE
CH1
KIND Velocity or flow rate.
RANGE TYPE Single, auto, or bi-dir.
FULL SCALE 1
FULL SCALE 2
RANGE HYS.
BURNOUT (CURRENT)
BURNOUT TIMER
OUTPUT LIMIT LOW
OUTPUT LIM. HIGH
RATE LIMIT
RATE LIMIT TIMER
FS 1(THERMAL)
FS 2(THERMAL)
Burnout setting.
CH2
CH3
TOTAL
CH1
TOTAL MODE
TOTAL RATE
TOTAL PRSET
PULSE WIDTH
BURNOUT (TOTAL)
Pulse width setting
Burnout setting
BURNOUT TIMER
TOTAL RATE (T)
TOTAL PRESET (T)
CH2
CH3
A01 OUT. SOURCE
CH2: FLOW RATE
CH3: FLOW RATE
A02 OUT. SOURCE
CH1: FLOW RATE
(Same as “A01 OUT. SOURCE”)
DO1 OUT
CH1
Do output setting for CH1 (total pulse, alarm, etc)
CH2
CH3
(Same as "CH1")
(Same as "CH1")
DO2 OUT
DO3 OUT
DO4 OUT
(Same as "DO1 OUT")
(Same as "DO1 OUT")
(Same as "DO1 OUT")
CALIBRATION ZERO CH1
CH2
CALIBRATION SPAN
CH1
CH2
OPERATION MODE NORMAL
HIGH SPEED
(Same as “CH1”)
(Same as “CH1”)
(Same as "CH1")
(Same as "CH1")
(Same as “CH1”)
(Same as “CH1”)
(Same as “CH1”)
2-pipe mode – parameter protection and output setup