Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 27 / 149

-20-
Measurement mode
PAR.PROTECTION
OUTPUT SETUP
MEASURE SETUP
CH1
*1
CH2
*1: No CH selection for 1-path mode.
CH3
MAINTENANCE MODE RAS INFORMATION
OUTPUT SETTING
TOTAL PULSE
AO1 CALIBRATION
AO2 CALIBRATION
DO CHECK
RESERVE 1
RESERVE 2
TEMP. CHECK
TEST MODE
COMMUNICATION MODE RS-485
BAUD RATE Baud rate setting
PARITY Parity setting
STOP BIT Stop bit setting
STATION No.
PROTOCOL Protocol setting
SYSTEM LANGUAGE Language settings
REGISTER ID NO.
VER. NO.
*3 MEMORY INITIAL *3: Only for service technician
LCD BACKLIGHT
LCD/LED CHECK
LCD/LED CHECK CH1
*1 *1: No CH selection for 1-path mode.
CH2
*3 DETAILS CH1
*1
128 (Initial value)
TRIGGER CONTROL
WINDOW CONTROL
128 (Initial value)
(METHDD2 (Initial value))
25% (Initial value)
(BURST3 (Initial value))
AGC GAIN
(Auto (Initial value))
(Auto (Initial value))
(Auto (Initial value))
(0.375V (Initial value))
5ms (Initial value)
*1
*1
CH2
CH ALL
(Same as “CH1”)
(Set the same values for CH1 and CH2)
TRANS. COUNT
SATURATION
MEAS. METHOD
SIGNAL BALANCE
TRANS. PATTERN
SIGNAL PEEK
TRANS.WAIT TIME
1-path and 2-path mode – maintenance mode