Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 25 / 149

-18-
4.3. Composition of key operation
The composition of key operation is shown below.
4.3.1. 1-path/energy measurement mode and 2-path mode
1-path and 2-path mode – parameter protection and output setup
Measurement mode
PAR.PROTECTION PROTECTION ON
PROTECTION OFF INPUT ID NO.
OUTPUT SETUP ZERO ADJUSTMENT CLEAR
SET ZERO
DAMPING
*1: No CH selection for 1-path mode.
DISPLAY 1ST.ROW Select which measured value (flow rate, velocity, totalized, etc) to be displayed on Display 1.
(Same as “CH1”)
(Same as “CH1”)
KIND RANGE
CUTOFF
CH1
*1
CH2
CH3
2ND.ROW (Same as “1ST”)
Velocity or flow rate.
RANGE TYPE Single, auto, or bi-dir.
FULL SCALE 1
FULL SCALE 2
RANGE HYS.
BURNOUT (CURRENT) Burnout setting.
BURNOUT TIMER
OUTPUT LIMIT LOW
RATE LIMIT
RATE LIMIT TIMER
FS 1 (THERMAL)
FS 2 (THERMAL)
OUTPUT LIM. HIGH
TOTAL Start, stop, or reset. TOTAL MODE
TOTAL RATE
TOTAL PRSET
PULSE WIDTH Pulse width setting
BURNOUT (TOTAL) Burnout setting
BURNOUT TIMER
TOTAL RATE (T)
TOTAL PRESET (T)
A01 OUT. SOURCE CH1:FLOW RATE
CH2:FLOW RATE *2
*2
*2
*2
*2: No selection of CH2 and CH3 for 1-path mode.
CH3:FLOW RATE
CH1:THERMAL FLOW
CH2:THERMAL FLOW
CH3:THERMAL FLOW
A02 OUT. SOURCE (Same as "A01 OUT. SOURCE")
CH1 Do output setting for CH1 (total pulse, alarm, etc)
*1
CH2 (Same as “CH1”) *1: No CH selection for 1-path mode.
CH3
(Same as “CH1”)
DO1 OUT
DO2 OUT (Same as “DO1 OUT”)
DO3 OUT (Same as “DO1 OUT”)
DO4 OUT (Same as “DO1 OUT”)
OPERATION MODE Normal or high-speed
CALIBRATION ZERO
CALIBRATION SPAN