Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 94 / 149

-87-
4.15. Maintenance mode
4.15.1. Copying the parameters
Description
 Set values of a parameter can be copied between channels. This function is available in 2-pipe measurement mode.
Channels to be copied
・
CH2
←
CH1 : Copy CH1 (Path 1) to CH2 (Path 2)
・
CH3
←
CH1 : Copy CH1 (Path 1) to CH3 (Calculated value)
・
CH1
←
CH2 : Copy CH2 (Path 2) to CH1 (Path 1)
・
CH3
←
CH2 : Copy CH2 (Path 2) to CH3 (Calculated value)
・
CH1
←
CH3 : Copy CH3 (Calculated value) to CH1
（
Path 1
）
・
CH2
←
CH3 : Copy CH3 (Calculated value) to CH2
（
Path 2
）
Contents to be copied
○
: Applicable,
－
: Not applicable
Parameter CH1 CH2 CH3
DAMPING
○ ○ －
CUTOFF
○ ○ －
RANGE
○ ○ ○
TOTAL
○ ○ ○
CALIBRATION ZERO
○ ○ －
OUTPUT SETUP
CALIBRATION SPAN
○ ○ －
FLOW UNIT
○ ○ ○
TOTAL UNIT
○ ○ ○
MEASURE
SETUP
PROCESS SETTING
○ ○ －
MAINTENANCE
MODE DETAILS
○ ○ －
<Note> If the total mode of the source channel is set to “RESET” or “START”, set the total mode of the destination channel to
“STOP”.
Before performing the totalization after copying parameters, be sure to set the total mode of the destination channel to
“RESET” according to the section 4.12.2.5.
When copying is completed, return to the measurement mode and turn OFF the power, and then power ON.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Copy CH3 (Calculated value) to CH1 (Path 1).
* Below is an example for 2-pipe measurement mode.
Key operation Description Display
０．０００ ｍ／ｓ
０．０００ ｍ３／ｈ
▼
Press the key for 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
ENT
▼
Press the
ENT
key once to display “RAS INFORMATION”.
RAS INFORMATION
ＣＨ１
▼
Press the key once to display “COPY”.
COPY
ＣＨ２ ← ＣＨ１
ENT
▼
Press the
ENT
key once to blink the display of second line.
COPY
ＣＨ２ ← ＣＨ１
▼
Press the key for 4 times to display “CH1
←
CH3” on the second
line.
COPY
ＣＨ１ ← ＣＨ３
Press the
ENT
key once to register.
COPY

COMPLETE

↓
ENT
▼
▼
▼
▼
―――
“COPY” has been registered.
―――
COPY
ＣＨ１ ← ＣＨ３
ESC
Press the
ESC
key once and the key once to return to the
measurement mode.
０．０００ ％
０．０００ ｍ３