Fuji Electric Time Delta-C FSV-2, Instruction Manual

Page: 46 / 149

-39-
4.11.2. Flow rate unit
Description
 Select the unit of flow rate.
 Metric system
Channel designation : CH1, CH2,CH3
* When using 2-pipe measurement, set all of CH1, CH2, and CH3.
* No channel setting is necessary for 1-path/energy measurement and 2-path measurement.
Flow rate ········· L/s, L/min, L/h, L/d, kL/d, ML/d, m
3
/s, m
3
/min, m
3
/h (factory set), m
3
/d, km
3
/d, Mm
3
/d, BBL/s, BBL/min, BBL/h, BBL/d,
kBBL/d, MBBL/d
<Note> First, set the unit system (metric) according to Section 4.11.1.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Set a flow rate unit to “L/min”.
* Below is an example for 1-path/energy measurement and 2-path measurement. Refer to Section 4.8.1 for channel
designation of 2-pipe measurement.
Key operation Description Display
▼
Press the key for 3 times to display “MEASURE SETUP”.
MEASURE SETUP
ENT
▼
Press the
ENT
key once to display “MEASUREMENT MODE”.
MEASUREMENT MODE
1 PATH
▼
Press the key twice to display “FLOW UNIT”.
FLOW UNIT
m3/h
ENT
▼
Press the
ENT
key once to blink the cursor.
FLOW UNIT
m3/h
▼
Press the key several times to display “L/min”.
FLOW UNIT
L/min
Press the
ENT
key once to register.
FLOW UNIT
 COMPLETE 
↓
ENT
▼
▼
▼
▼
――― “L/min” has been registered. ―――
FLOW UNIT
L/min
ESC
Press the
ESC
key once and the key twice to return to the
measurement mode.
0.000 m/s
0.000 L/min