fSONA Sonabeam E Series, Installation Manual

Page: 59 / 87

Initial Power Up and Terminal Configuration
wireless at the speed of light
…………….
49
S
O
N
A
b
e
a
m
E
-S
e
ri
e
s
In
st
a
lla
ti
o
n
M
a
n
u
a
l
NOTE…
Refer to the SONAbeam Terminal Controller Software User Guide for
information on installing and using the software on your computer…
Connecting a PC to your SONAbeam Terminal
A temporary setup connection between your PC w/STC and the SONAbeam is made
through a simple serial or USB interface, as illustrated in
Figure 18
.
Figure 18 – Connecting your new SONAbeam to STC Software
Simply use a suitable cable to connect your Terminal Controller (PC) to the appropriate
RS232 MGMNT
or the USB
MGMNT
connector inside the terminal’s Customer Interface
Area.
NOTE…
If your installation includes a permanent serial interface to your SONAbeam,
temporarily disconnect it while performing the initial terminal setup…
USB Connection
A Universal Serial Bus (USB) connection is a simple plug n’ play affair using a standard
Type A to Type B USB cable. (One is supplied in the optional Basic Alignment Kit.)
SONAbeam Terminal
PC (with STC Software)
Serial/USB Interface