If the head of the rotary agitator is not adequately covered by the remaining fuel:
❒ Close all openings to the store to seal out dust
❒ Load a small amount of fuel (approx. 2-3 m³)
➥ Pile it up on and around the head of the rotary agitator
➥ The head of the rotary agitator should be completely covered
Rotary agitator with combined drive system
After working in the store:
❒ Turn on the boiler’s main switch
❒ Turn on the main switch on the expansion switch cabinet (if installed)
❒ Switch on main switch at feed system module
❒ Switch on the boiler by tapping “Boiler on” at the mode icon
❒ For the highest possible heat consumption
➥ the storage tank must be able to store enough heat
❒ Wait until the rotary agitator arms / spring blades are touching the head of the
rotary agitator (approx. 2 revolutions)
❒ Close all openings to the store to seal out dust
❒ Add the rest of the fuel
5.4 During operation
The boiler is controlled by the boiler controller. The discharge system switches on and
off automatically when material is requested.
When filling, or in the event of a fault, the system is operated in manual mode (H
3200).
For the necessary steps, and how to display and alter parameters:
NOTICE! See operating instructions for boiler controller
NOTICE
When transporting wood chips or pellets using the feed screw, there may be
noise, depending on the function.
Operating the system
5
Filling the store with fuel
Installation Instructions TGR 110/150/200 | M1390116_en
37
