3.
Using the flywheel, manually set the movable crushing jaw to the
lowermost position. This corresponds to the smallest gap.
CAUTION!
Crushing hazard!
Do not get fingers caught between the crushing
plates!
The gap width between the two crushing plates
can be checked from below using a feeler gauge.
The gap width should be between 0.5 mm and 1
mm.
4.
The gap width can be readjusted by removing or inserting compen-
sation plates (marked red in the image) under the pressure plate
on the fixed crushing jaw.
NOTICE!
During operation of the jaw crusher, the crushing
plates must not touch when the smallest gap
width is set.
6.3.3 Attaching the support walls
CAUTION!
Crushing hazard!
Two persons are required to remove the flywheel due
to the heavy weight.
Replacing the support walls is only necessary when the crushing jaws
have been replaced because their material has to be changed and
because abrasion of the support walls, however slight, must be avoided.
Using the device
- 31 -