The tungsten carbide equipment is recommended for crushing very hard
material or to avoid ferrous contaminants.
6.3 Replacing the crushing plates and support walls
DANGER!
Mains voltage!
– Before beginning with maintenance and assembly
work, disconnect the mains plug and protect the
device against being unintentionally switched back
on!
– Indicate maintenance and assembly work with
warning signs.
When the of the PULVERISETTE 1 classic line is delivered, one set of
crushing plates and the support walls are firmly attached. The PULVERI-
SETTE 1 classic line is ready to use after connecting the electricity.
The crushing jaws (and the support walls to an extremely small extent)
are subject to wear and must also be turned over and then replaced at a
later time.
NOTICE!
Make sure the crushing plates on the right and left
sides protrude somewhat beyond the crushing jaws.
If it is noticed during an inspection or while cleaning
that only the lower parts of the crushing jaws are worn,
the symmetrical jaws can be simply turned over.
The fixed and movable crushing jaws have different
forms.
The surfaces of the fixed crushing plate are exactly par-
allel; the moveable crushing jaw is convex on the
crushing side, and it is somewhat longer.
Using the device
- 28 -